3D Printing Projects:
Design, Printing, Implementation

17mm Lens Cap Project

Updated 1/1/19

 

      
 This replaces
      the terrible wimpy lens cap that came with the lens, which was
      always falling off.

      

        

          
 
          
 The
            lens cap fits over the entire end of the lens, unlike the original
            which only grabbed the outer 2mm. This one is a full half inch
            thick and really slides on beautifully.
 
        
      

      

        

          
 
          
 Installed
            and doing its job - Keeping an expensive lens safe!
 
        
      


HOME